How To Light A Water Heater With Electronic Pilot Youtube

How To Light A Water Heater With Electronic Pilot Youtube

How To Light A Water Heater With Electronic Pilot Youtube. Hold the red button down while pressing the piezo ignitor striker, found to the immediate right of the gas knob, repeatedly until the pilot is lit. Use a flashlight or a headlamp to find the burner inside.

How To Light A Water Heater With Electronic Pilot YoutubeHow To Light A Water Heater With Electronic Pilot Youtube
How to Light a Water heater pilot (new style) YouTube from www.youtube.com

How do you light a gas water heater with electronic pilot? It will give you the opportunity to light the fire if the gas flowing starts to fill up. Bend the thermocouple back into its original position.

Right After A Second, Press The Ignition Button Till The Status Light Begins To Blink Every Few Seconds.

Some water heaters have a separate button for pilot mode, usually a red one, which you'll press and hold. Turn the water temperature dial to low and the on/off/pilot dial to pilot. Turn the gas valve to the pilot setting and push down on it.

A Separate Button For Pilot Mode, Usually Red, Is Included In Some Water Heaters.

Lighting the pilot light for a standing pilot gas. This will start the flow of gas so you can light the flame. Turn the gas valve counterclockwise until it reads 'pilot.' push the red 'reset' button and hold it down while you light the pilot burner with a match.

Here Are Some Instructions On How To Do So.

Things you need for this tutorial. Bend the thermocouple back into its original position. When in pilot mode, press and hold it.

Turn The Gas Knob To “Pilot,” Press And Hold It Down.

Dial or rotate the gas control knob to the pilot position. While still holding down the gas, light that pilot and the pilot should be shown the door. When it’s bent to a certain extent away from the pilot light, it’s no longer functional because it won’t be able to detect the heat.

Once Done, Turn On The Gas Valve.

Use a flashlight or a headlamp to find the burner inside. The reason is that the thermocouple has not heated sufficiently! Turn the gas knob to “pilot,” press and hold it down.

Leave a Reply

Your email address will not be published.