Whirlpool Duet Dryer Won't Start Says Sensing

Whirlpool Duet Dryer Won't Start Says Sensing

Tags: , ,

Whirlpool Duet Dryer Won't Start Says Sensing. Check all connects to be sure everything is plugged in good and doesn’t show sighs of corrosion. We change the thermal fuse still not working still same issue.

Whirlpool Duet Dryer Won't Start Says SensingWhirlpool Duet Dryer Won't Start Says Sensing
Whirlpool duet dryer model GEW9200LW1 won't run. All from www.justanswer.com

Sometimes the touch screen itself can break. Click to see full answer. If the water drains from the unit, but your whirlpool washer won’t spin, you may have a problem with the shift actuator.

We Change The Thermal Fuse Still Not Working Still Same Issue.

10 votes) all whirlpool duet dryers have sensor strips in the drum. If your whirlpool washer won’t drain, you cannot use the spin function or whirlpool won’t start a new wash cycle. The status remains on sensing and the timer numbers do count down.

Whirlpool Duet Electric Dryer, Sensing Light Lit But No Go 5 Replies It Was A Crisp Fall Morning Here In New Hampster When The Call Came In.

If it doesn't turn on, check your power cord and the house circuit breaker. That’s why your whirlpool dryer is stuck in sensing mode. Whirlpool duet electric dryer, the sensing light comes on, control panel responds to the buttons, but it just won’t start running.

New Whirlpool Washer Stuck On Sensing.

You need to make sure that your washing machine is in standby mode. Whirlpool dryer wont start says sensing saintjohn from floridaodysseyofthemind.org. To test this, you will need to press the start switch.

Washer Machine In Standby Mode.

Whirlpool cabrio dryer won't start says sensing. Empty your wet laundry into a tray. If your whirlpool washer won’t drain, you cannot use the spin function.

You May Have A Harness Problem.

All whirlpool duet dryers have sensor strips in the drum. I have a whirlpool duet sport dryer model # wed8300sw0 when you turn on the dryer it will spin for 10 seconds and then state sensing and stop , if we wait for sensing to complete it will then start and stop. Unplug the dryer and remove the front panel.

Leave a Reply

Your email address will not be published.